Filter
Top Products
2-9
Compaq ProLiant 1850R Servers Maintenance and Service Guide
Power/Standby Switch with LEDs
To remove the power/standby switch with LEDs:
1. Perform the preparation procedures. See page 2-4.
2. Remove the server cover. See page 2-7.
3. Remove the diskette drive. See page 2-27.
4. Remove the two female connectors 1.
5. Remove the LEDs from the holders in the power/standby switch 2.
1
2
3
4
5
Figure 2-3. Removing the power/standby switch with LEDs
6. Push inward slightly at points 3 and 4 to release the power/standby switch from
the bezel.
7. Remove the switch parts from the bezel 5.
Reverse steps 1 through 7 to replace the power/standby switch with LEDs.
NOTE
: The LEDs have one flat side, which must be correctly oriented
before insertion into
the holder.