2-7
Compaq ProLiant 1850R Servers Maintenance and Service Guide
Server Cover
Remove the server cover to gain access to drive bays, expansion slots, boards, and switches
inside the server. To remove the server cover:
1. Perform the preparation procedures. See page 2-4.
2. Loosen the three captive thumbscrews on the rack-mount bezel.
3. Use the grip slot to slide the cover toward the rear of the unit about 1 inch (2.5 cm).
4. Move the server cover to the right side of the unit.
5. Lift off the server cover.
Figure 2-1.Removing the server cover
Reverse steps 1 through 5 to replace the server cover.