2-27
Compaq ProLiant 1850R Servers Maintenance and Service Guide
Diskette Drive
To remove the diskette drive:
1. Perform the preparation procedures. See page 2-4.
2. Remove the server cover. See page 2-7.
3. Disconnect the power and data cables from the diskette drive (if installed).
4. Remove one T-15 screw 1 from the diskette drive.
5. Slide the diskette drive back, then away from the front bezel until it stops.
NOTE
: Make sure the diskette eject lever clears the bezel when removing
the diskette drive. Slide the diskette drive straight back from the front of
the unit.
6. Pull the diskette drive out 2 and lift it from the chassis 3.
Front
View
2
3
1
Figure 2-21. Removing the diskette drive
Reverse steps 1 through 6 to replace the diskette drive.
NOTE
: Make sure the diskette eject lever clears the bezel. Slide the
diskette drive toward the back, then push it to the front of the unit.
External Storage Devices
You can connect optional mass storage devices to the ProLiant 1850R by using the external
Wide-Ultra SCSI-3 port on the back of the unit.