Filter
Top Products
4-3
Compaq ProLiant 1850R Servers Maintenance and Service Guide
SCS I Devices
No two SCSI devices connected to the same SCSI controller can have the same SCSI ID. If
another SCSI device is connected to the same controller, check its SCSI ID in the Compaq
System Configuration Utility before beginning installation procedures for an additional drive
(see Chapter 3). The SCSI ID is set by jumpers ID 2, ID 1, and ID 0 located on each SCSI
device.
The following chart provides the SCSI ID jumper settings for Compaq SCSI hard drives.
Table 4-2
SCSI ID Settings
SCSI ID Bit 2 Bit 1 Bit 0
6ON ON OFF
5ON OFF ON
4ON OFF OFF
3 OFF ON ON
2 OFF ON OFF
1OFF OFF ON
0 OFF OFF OFF