Filter
Top Products
Configuring the GbE Interconnect Switch Using the Web-Based Management Interface
Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide 4-11
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 10:02 AM
3. Configure the Speed/Duplex setting for the port:
NOTE: If you have the ProLiant BL p-Class F-GbE Interconnect Kit option with the DualTSX
Interconnect Modules, the management interface supports only 1000M/Full and Auto options for
the Speed/Duplex fields for the Gigabit uplink ports. The fiber DualTSX Interconnect Module
supports only 1000-Mb/s (Gigabit) speed, and not 10-Mb/s or 100-Mb/s.
— Select Auto to allow the port to select the best transmission speed, duplex mode, and
flow control settings based on the capabilities of the device at the other end. The
other selections allow you to force the port to operate in the specified manner.
— Select 1000M/FULL for port operation at 1000 Mb/s and full duplex.
— Select 100M/FULL for port operation at 100 Mb/s and full duplex.
— Select 100M/HALF for port operation at 100 Mb/s and half duplex.
— Select 10M/FULL for port operation at 10 Mb/s and full duplex.
— Select 10M/HALF for port operation at 10 Mb/s and half duplex.
4. Configure the Flow Control setting for the port:
— Select On for flow control.
— Select Off for no flow control.
IMPORTANT: You must reboot the GbE Interconnect Switch before a flow control change can take
effect.
5. Click Apply.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the Maintenance menu. Refer to the section, “Saving Changes,”
earlier in this chapter.