Filter
Top Products
Configuring the GbE Interconnect Switch Using the Console Management Interface
Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide 3-27
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
6. Set the state of each port by highlighting the Tag/Untag field using the arrow keys and
then toggling between U and T using the spacebar.
— U—Specifies the port as an untagged member of the VLAN. When the port transmits
an untagged packet, the packet header remains unchanged. When a tagged packet
exits the port, the tag is stripped and the packet is changed to an untagged packet.
— T—Specifies the port as a tagged member of the VLAN. When the port transmits an
untagged packet, the packet header is changed to include the 32-bit tag associated
with the PVID (Port VLAN Identifier). When a tagged packet exits the port, the
packet header is unchanged.
NOTE: If the port is attached to a device that is not IEEE 802.1Q VLAN compliant (VLAN-tag
unaware), then set the port to U (Untagged). If the port is attached to a device that is IEEE 802.1Q
VLAN compliant (VLAN-tag aware), then set the port to T (Tagged).
7. Toggle the State field between Active and Inactive.
8. Highlight APPLY and press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier in this
chapter.
Configuring a Port VLAN
To assign a port a PVID:
1. Highlight Configure Port VLAN ID on the IEEE 802.1Q VLANs
Configuration menu.
2. Press the Enter key. The following screen is displayed.
3. Type the range of port numbers you want to configure in the Configure Port field.