Filter
Top Products
Configuring the GbE Interconnect Switch Using the Console Management Interface
3-28 Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
4. Type the PVID for the VLAN member ports you want to configure in the PVID field.
PVID is a classification mechanism that associates a port with a specific VLAN and is
used to make forwarding decisions for untagged packets received by the port. For
example, if Port 2 is assigned a PVID of 3, then all untagged packets received on Port 2
will be assigned to VLAN 3. This number is generally the same as the VID number
assigned to the port in the 802.1Q Static VLAN Settings screen.
5. Highlight APPLY and press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier in this
chapter.
Configuring Port Ingress Filtering
To set ingress filtering on a port:
1. Highlight Configure Port Ingress Filter on the IEEE 802.1Q VLANs
Configuration menu.
2. Press the Enter key. The following screen is displayed.
3. Type the range of port numbers you want to configure in the Configure Port fields.
4. Toggle between On and Off in the Ingress Filter field.
An ingress filter enables the port to compare the VID tag of an incoming packet with the
PVID number assigned to the port. If the two are different, the port filters (drops) the
packet.
5. Highlight APPLY and press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier in this
chapter.