Filter
Top Products
Configuring the GbE Interconnect Switch Using the Console Management Interface
Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide 3-41
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
— Src.Addr—Packets with the selected MAC address as their source will be given the
selected priority.
— Either—All packets with the selected MAC address will be given the selected
priority.
6. Highlight APPLY and press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into non-volatile RAM
(NVRAM) using the Save Changes option on the main menu. Refer to the “Saving Changes”
section earlier in this chapter.
Configuring RS232 and SLIP
To configure RS232 and Serial Line Internet Protocol (SLIP):
1. Highlight Configure RS232 and SLIP on the Configuration menu.
2. Press the Enter key. The following screen is displayed.
The Serial Port and SLIP Settings window allows you to configure the GbE
Interconnect Switch serial port through either the console port or through use of the
Telnet protocol.
You can set the following features:
— Baud Rate—Specifies the rate at which data will be exchanged over the serial link.
The default value is 9600 baud.
— Data Bits—Specifies the number of bits that will carry data over the serial link. The
default value is 8 bits.
— Stop Bits—Specifies the number of bits that indicate when a serial word ends. The
default value is 1 bit.