Filter
Top Products
Configuring the GbE Interconnect Switch Using the Console Management Interface
3-52 Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
To set the SNMP Manager Configuration settings:
1. Highlight SNMP Manager Configuration on the main menu.
2. Press the Enter key. The following screen is displayed.
The following SNMP Manager and Trap Manager Configuration parameters can be set:
— SNMP Community String—Displays the community string that is included on
SNMP packets sent to and from the GbE Interconnect Switch. Any station not privy
to this community does not receive the packet.
— Access Right—Allows each community to be separately set to either Read Only,
meaning that the community member can only view switch settings, or Read/Write,
which allows the member to change settings in the GbE Interconnect Switch.
— Status—Determines whether this community name entry is Valid or Invalid. An
entry can be disabled by changing its status to Invalid.
— IP Address—Displays the IP address of the network management station designated
to receive traps.
— Security IP—Allows you to create a list of IP addresses that are allowed to access
the GbE Interconnect Switch by means of SNMP or Telnet.
3. After making your changes, highlight APPLY, then press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier in this
chapter.