Filter
Top Products
Configuring the GbE Interconnect Switch Using the Console Management Interface
3-14 Compaq ProLiant BL p-Class GbE Interconnect Switch User Guide
COMPAQ CONFIDENTIAL Codename: Vanilla Part Number: 263680-001 Last Saved On: 4/23/02 9:59 AM
— Scheduling Mechanism for CoS Queues—Provides two possibilities for setting
Class of Service queue options, RoundRobin and Strict. If you select Strict, when
the highest priority queue is full, those packets are the first to be forwarded. If you
select RoundRobin, the forwarding is based on the settings made on the Class of
Service Configuration screen.
— Trunk Load Sharing Algorithm—Sets options for trunk load sharing. The trunk
load sharing options are Dst Address, Src&Dst Address, and Src Address.
— Backpressure—Select Enabled or Disabled to initiate or terminate traffic flow
control in and out of the switch.
NOTE: A very long aging time can result in out-of-date Dynamic Entries that may cause incorrect
packet filtering and forwarding decisions. A very short aging time may cause entries to be aged out
too soon, resulting in a high percentage of received packets whose source addresses cannot be
found in the address table, in which case the GbE Interconnect Switch will broadcast the packet to
all ports, negating many of the benefits of having a switch.
3. After making your changes, highlight APPLY, then press the Enter key.
NOTE: To save the configuration settings permanently, you must enter them into NVRAM using
the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier in this
chapter.
Configuring Port Settings
To configure ports:
1. Highlight Configure Ports from the Configuration menu.
2. Press the Enter key. The following screen is displayed.
3. Toggle the View Ports field, using the spacebar, to display the configuration of
Ports 1 through 12 or Ports 13 through 24.