Filter
Top Products
2-24
Getting started
User’s Guide for the Magna™ Class Printer
Power on the printer
1 Make sure cards and all other supplies are loaded. See other
sections of this chapter for more information.
2 Remove any printed or rejected cards from the output tray. See
“Removing cards” on page 3-13 for more information.
3 Make sure the power cord and interface cable are connected. If
needed, see “Connecting the printer” on page 2-9 for more
information.
4 Press the printer Power button to turn on power. Observe the
printer panel light. See “Printer features” on page 1-5 for more
information. The printer initializes all components and makes
audible sounds.
Figure 2-21: Turn on power to the printer
After model ML and M2L printers are powered on, the overlay
module requires about 10 minutes to heat up from room
temperature before printing a card. If a card was sent to print
before the overlay module has heated up, the printer will pick the
card but will not print or apply overlay until the overlay module
has heated up. If the printer power was on recently, warm-up time
i
E
MagnaUserGuide.book Page 24 Friday, May 5, 2000 1:09 PM