Datacard Group SP Series Printer User Manual


 
2-4
Getting started
Users Guide for the Magna Class Printer
Figure 2-2: Magna Class ML and M2L models dimensions and
clearance
The clearance required is:
3 inches (7.5 cm) in back of the printer, for an overall depth of
13.25 inches (31.1cm)
6 inches (15.3 cm) on the left end of the printer and 2 inches (5.1
cm) on the right (output) end to remove the card cartridge and
card output stacker. The overall width needed for the M and M2
models is 34.75 inches (88.3 cm) and the overall width for ML
and M2L models is 42.75 inches (109.7 cm).
10.5 inches (26.7 cm) above the printer to allow the cover to
open, for an overall height from the work surface of 23.75 inches
(60.3 cm).
Environmental requirements
The Magna Class printer requires the following environmental
conditions for optimal operation:
Operating relative humidity: 20% to 80% non-condensing
Operating temperature range: 55° F to 95° F (13° C to 35° C)
10.5 in
(26.7 cm)
13.25 in
(33.7 cm)
34.75 in
(88.3 cm)
10.25 in
(26.1 cm)
3 in
(7.5 cm)
6 in
(15.3 cm)
2 in
(5.1 cm)
MagnaUserGuide.book Page 4 Friday, May 5, 2000 1:09 PM