Filter
Top Products
Troubleshooting
6-9
#
Obtain guidance from service before performing this task.
User’s Guide for the Magna™ Class Printer
The topcoat shows bands
across the width of the
card.
The printhead intensity is
too low.
The printhead is not
aligned correctly.
Increase the printhead
intensity setting for
topcoat. See Chapter 5.
#
Contact your service
representative.
The topcoat shows lines
along the length of the
card.
The printhead intensity is
too high.
The printhead is not
aligned correctly.
Lower the printhead
intensity setting for
topcoat. See Chapter 5.
#
Contact your service
representative.
A short edge of the
topcoat does not stick to
the card.
The printhead intensity is
too low.
The printhead is not
aligned correctly.
Increase the printhead
intensity setting for
topcoat. See Chapter 5.
#
Contact your service
representative.
Table 6-2: Topcoat quality problems—print ribbon
What you see Possible causes Solutions
MagnaUserGuide.book Page 9 Friday, May 5, 2000 1:09 PM