Datacard Group SP Series Printer User Manual


 
Getting started
2-19
Users Guide for the Magna Class Printer
4 Remove the empty spool from the supply spool holder and press
the spool into place on the take-up spool holder of the cartridge
(step 1 in Figure 2-18). Make sure the ribs inside the spool align
with the grooves in the spool holder.
5 Press on the spool and turn the spool slightly (if needed) until the
spool fully covers the spool holder ribs.
6 Unwrap the new overlay supply material.
7 Place the full supply roll on the right spool holder as you face the
open side of the cartridge (step 2 in Figure 2-18). Make sure the
supply will unroll counterclockwise , as shown.
Figure 2-18: Load overlay in the cartridge
8 Make sure the ribs inside the spool align with the grooves in the
spool holder. Press on the spool and turn the supply roll slightly (if
needed) until the spool fully covers the spool holder ribs.
9 Lift the label on the supply roll and unroll about 8 inches from the
supply roll.
10 Wind the supply material in front of the guides and around the
take-up spool (step 3 in Figure 2-18). Make sure that the material
will wind counterclockwise .
11 Press the label onto the take-up spool to secure the supply
material, as shown (step 4 in Figure 2-18).
1
2
4
3
Take-up spool
Supply roll
MagnaUserGuide.book Page 19 Friday, May 5, 2000 1:09 PM