Filter
Top Products
2-22
Getting started
User’s Guide for the Magna™ Class Printer
Set the debower
Do not use the debower in the On position with proximity cards or
smart cards.
Make sure power to the printer is off.
1 Lift the top cover, and then move the support down so it rests on
the internal frame, as shown in Figure 2-12.
The overlay module is HOT to the touch and remains HOT for
up to 30 minutes after the printer is powered off.
2 Pull out the handle for the debower and move it to the desired
position for the card type. Figure 2-20 shows the on and off
positions for the debower.
If you use an overlay station, you must use cards that are at
least 0.030 inch or 0.760 mm thick.
Make sure the debower is seated in the latch.
E
Card type Debower position
0.030 inch (0.76 mm) card on
0.050 (1.27 mm) cards off
Smart card off
Proximity card off
E
MagnaUserGuide.book Page 22 Friday, May 5, 2000 1:09 PM