2-30
Getting started
User’s Guide for the Magna™ Class Printer
Allow 30 to 60 seconds for the printer to begin printing the test
card. The status light will flash green while the Magna Class
printer is processing the data.
Figure 2-23: Press the Power button (2) while pressing and
holding the Ready button (1)
After model ML and M2L printers are powered on, the overlay
module requires about 10 minutes to heat up from room
temperature before printing a card. If a card was sent to print
before the overlay module has heated up, the printer will pick the
card but will not print or apply overlay until the overlay module
has heated up. If the printer power was on recently, warm-up time
is shorter. The overlay module makes a series of beeps while it is
warming up.
5 Remove the card from the card output stacker.
The printer test card is shown in Figure 2-24 on page 2-31.
If the printer test card did not print successfully, see “Setup tips”
on page 2-28. If needed, turn to “Troubleshooting” on page 6-1.
♦
2
1
i
E
MagnaUserGuide.book Page 30 Friday, May 5, 2000 1:09 PM