Filter
Top Products
Does the OpenManage Integration for VMware vCenter support the VMware vCenter
Server appliance?
Yes, the OpenManage Integration for VMware vCenter supports the VMware vCenter Server appliance.
Does the OpenManage Integration for VMware vCenter support the vSphere Web Client?
Yes, the OpenManage Integration for VMware vCenter supports the VMware vSphere Web client.
In the Administration Console, why the Update Repository Path is not set to default path
after I reset the appliance to factory settings?
After you reset the appliance, go to the Administration Console, and then click APPLIANCE MANAGEMENT in the left
pane. In the Appliance Settings page, the Update Repository Path is not changed to default path.
Resolution: In the Administration Console, manually copy the path in the Default Update Repository field to Update
Repository Path field.
After backup and restore of OpenManage Integration for VMware vCenter, why alarm
settings are not restored?
Restoring the OpenManage Integration for VMware vCenter appliance backup does not restore all the Alarm settings.
However, in the OpenManage Integration for VMware GUI, the Alarms and Events field displays the restored settings.
Resolution: In the OpenManage Integration for VMware GUI, in the Manage → Settings tab, manually change the Events
and Alarms settings.
Bare Metal Deployment Issues
This section deals with issues found during the deployment process.
Auto-Discovery and Handshake Prerequisites
• Prior to running auto-discovery and handshake, make sure that iDRAC and Lifecycle Controller firmware and BIOS
versions meet the minimum recommendations.
• CSIOR must have run at least once on the system or iDRAC.
Hardware Configuration Failure
• Before initiating a deployment task, make sure the system has completed CSIOR and is not in the process of
rebooting.
• It is highly recommended that BIOS configuration be run in Clone mode, so that the reference server is an identical
system.
• Some controllers do not allow creation of a RAID 0 array with one drive. This feature is supported only on high-end
controllers, and the application of such a hardware profile can cause failures.
Enabling Auto-Discovery On A Newly Purchased System
The auto-discovery feature of a host system is not enabled by default; instead, enablement must be requested at the
time of purchase. If auto-discovery enablement is requested at the time of purchase, DHCP is enabled on the iDRAC and
admin accounts are disabled. It is not necessary to configure a static IP address for the iDRAC. It gets one from a DHCP
server on the network. To make use of the auto-discovery feature, a DHCP server or a DNS server (or both) must be
configured to support the discovery process. CSIOR has already been run by factory process. For more information on
91