Filter
Top Products
244 Understanding the Printer Menus
WPS Setup
NOTE: WPS Setup is available only when the printer is connected using the wireless network.
Purpose:
To configure the wireless network using WPS.
Va lues:
IP Mode
Purpose:
To configure the IP mode.
Va lues:
TCP/IP
Purpose:
To configure TCP/IP settings.
Va lues:
Transmit Key Specifies the transmit key from Auto
*
,
WEP Key 1, WEP Key 2, WEP Key 3,
and WEP Key 4.
Ad-hoc Select to configure the wireless setting without the access
point such as a wireless router.
No Security
*
Select to configure the wireless setting without specifying
the encryption type from WEP.
WEP Specifies the WEP key to use through the wireless network.
For 64bit keys, up to 10 hexadecimal characters can be
entered. For 128bit keys, up to 26 hexadecimal characters
can be entered.
Transmit Key Specifies the transmit key from WEP
Key 1
*
, WEP Key 2, WEP Key 3, and
WEP Key 4.
Push Button Control
*
Start Configuration Configures the wireless setting with WPS-PBC.
PIN Code Start Configuration Configures the wireless setting using the PIN code assigned automatically by
the printer.
Print PIN Code Prints the PIN code. Confirm it when entering PIN assigned to the printer
into your computer.
Dual Stack
*
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
Get IP Address AutoIP
*
Sets the IP address automatically. A random value in the range of 169.254.1.0
to 169.254.254.255 that is not currently in use on the network is set as the IP
address. The subnet mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.