Filter
Top Products
414 Printing Using ColorTrack (External Authentication)
When Using the Operator Panel
You can specify only the settings of ColorTrack Mode, Non Registered User, and ColorTrack Error Report using the
operator Panel.
1
Press the
(Information)
button.
2
Select the
Tools
tab, and then select
Admin Settings
.
3
Select until
System Settings
appears, and then select
System Settings
.
4
Select until
ColorTrack Mode
appears, and then select
ColorTrack Mode
.
5
Select
External Mode
, and then select
OK
.
6
Select until
Non Registered User
appears, and then select
Non Registered User
.
7
Select
Off
or
On
, and then select
OK
.
8
Select until
ColorTrack Error Report
appears, and then select
ColorTrack Error Report
.
9
Select
Off
or
On
, and then select
OK
.
10
Turn off the printer, and turn it on again to apply the settings.
ColorTrack Mode
The following two authentication modes are available: the Internal Mode using user information registered on the
printer, and the External Mode using user information registered on an external server. To authenticate on the
external authentication server with External Mode, you need not register user information on the printer. The
change becomes effective after the printer is turned off and then on again.
Non Registered User
Specify whether to permit the printing of data with no authentication information. This setting is enabled when the
printer is restarted. The change becomes effective after the printer is turned off and then on again.
Non Registered User Password
Specify the password to be used for non-account user using 1 to 127 alphanumeric characters. If the password is left
blank (NULL), you cannot log in to a server. The change becomes effective after the printer is turned off and then
on again.
NOTE: When External Mode is specified and Non Registered User is set to On, you must set a password.
NOTE: When using an LDAP server, you also must set the same password on the server.
Re-enter Non Registered User Password
Enter the Non Registered user password again to confirm it.
ColorTrack Error Report
Specify whether to automatically print error-related information if printing using ColorTrack results in an error.
Setup Remote Authentication
Click Setup Remote Authentication Page to display the Authentication System page.
NOTE: This item is displayed only when External Mode is specified.
Authentication System
Specify the server authentication type, the server response time-out, or the search time-out.