Filter
Top Products
Installing Optional Accessories 61
WPS-PBC
You can start Push Button Control only from the operator panel.
NOTE: WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required
for wireless configuration by pressing the button provided on the access point via wireless routers, and then performing WPS-
PBC setting on the operator panel. This setting is available only when the access point supports WPS.
NOTE: Before starting WPS-PBC, confirm the position of the WPS button (button name may vary) on the wireless LAN access
point. For information about WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless
LAN access point.
1
Press the
(Information)
button.
2
Select the
Tools
tab, and then select
Admin Settings
.
3
Select until
Network
appears, and then select
Network
.
4
Select until
Wireless
appears, and then select
Wireless
.
5
Select until
WPS Setup
, and then select
WPS Setup
.
6
Select
Push Button Control
.
7
Select
Start Configuration
.
Ensure that the message
Setting WPS
is displayed, and start the WPS-PBC on the wireless LAN access point
(Registrar) within two minutes.
8
When the WPS operation is successful and the printer is rebooted, wireless LAN connection setting is completed.
Operator Panel
Auto SSID Setup
1
Press the
(Information)
button.
2
Select the
Tools
tab, and then select
Admin Settings
.
3
Select until
Network
appears, and then select
Network
.
4
Select until
Wireless
appears, and then select
Wireless
.
5
Select until
Wireless Setup Wizard
appears, and then select
Wireless Setup Wizard
.
The printer automatically searches the access points on wireless network.
6
Select until the desired access point appears, and then select the access point.
If the desired access point does not appear, go to "Manual SSID Setup."
NOTE: Some hidden SSID may not be displayed. If the SSID is not detected turn on SSID broadcast from the router.
7
Select
Next
.
8
Enter the WEP key or pass phrase.
When the encryption type of the selected access point is WEP in step 6:
a
Select the
WEP Key
text box, and then enter the WEP key.
b
Select
OK
.
When the encryption type of the selected access point is WPA, WPA2 or Mixed in step 6:
a
Select the
Pass Phrase
text box, and then enter the pass phrase.
b
Select
OK
.
9
The
Restart System
screen appears.
10
Turn off the printer, and turn it on again to apply the settings.