Filter
Top Products
374 Faxing
Sent Fax Fwd You can set your printer to forward incoming faxes to another fax
number, or forward them to an e-mail address. When a fax arrives
at your printer, it is stored in the memory. Then, the printer dials
the fax number you have specified in
Forwarding Number
or sends an e-mail to the address you have specified in
Forwarding E-mail Address 1-5.
To forward to a fax number, you need to register a fax number on
Forwarding Number. To forward to an e-mail address, you
need to register information on
E-mail Alert and
Forwarding E-mail Address. For information on e-
mail alert, see "E-Mail Alert" and on forwarding number and e-
mail address, see "Fax Settings."
Select
Off not to forward incoming faxes.
Select
Forward to forward incoming faxes without printing. If
an error occurs during forwarding a received fax, the printer prints
the fax.
Select
Print and Forward to forward and print incoming
faxes.
Select
Print and E-mail to print and forward incoming
faxes to e-mail.
2 Sided Print You can set whether to make duplex print when you print faxes.
Select
Off to print faxes on one side of a sheet of paper.
Select
On to print faxes on both sides of a sheet of paper.
Remote Receive You can receive a fax by pressing the remote receive code on the
external telephone after picking up the handset of the telephone.
When you set
Remote receive to On, specify a two digit
remote receive code in
Remote Receive Tone.
Discard Size When receiving a document as long as or longer than the paper
installed in your printer, you can set the printer to discard any
excess at the bottom of the page. If the received page is outside
the margin you set, it will print on two sheets of paper at the
actual size. When the document is within the margin and
Discard Size is set to Auto Reduction, the printer
reduces the document to fit it onto the appropriate sized paper
and discard does not occur. If
Discard Size is set to other
than Auto Reduction, the data within the margin will be
discarded.
Transmission
Defaults
Auto Redial Setup Resend Delay You can specify the interval between transmission attempts within
the range of 3 to 255 seconds. The default is 8 seconds.
Redial Attempts You can specify the number of redial attempts to make when the
destination fax number is busy, within the range of 0 to 13. If you
enter 0, the printer will not redial.
Interval of Redial Your printer can automatically redial a remote fax machine if it
was busy. Intervals from 1–15 minutes can be entered.
Tone/Pulse You can select the dialing type.
•Tone
•
Pulse(10PPS)
•
Pulse(20PPS)
Option Description