Filter
Top Products
Installing System Board Options 8-5
4. Insert the expansion card into the expansion-card connector.
If the expansion card is full-length, insert the front end of the card into the corre-
sponding card guide on the inside front of the chassis as you insert the card into
its connector.
Insert the card’s edge connector firmly into the expansion-card slot. Gently rock
the card into the connector until it is fully seated (see Figure 8-4).
5. When the card is firmly seated in the connector, secure the card’s mounting
bracket to the chassis with the screw you removed in step 3.
6. Connect any cables that should be attached to the card.
See the documentation that came with the card for information about the card’s
cable connections.
7. Replace the computer cover, and reconnect your computer and peripherals to
their power sources and turn them on.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
8. To reset the chassis intrusion detector, enter the System Setup program and
reset Chassis Intrusion to Not Detected.
See Chapter 3, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
expansion card
card-edge
connector
expansion-card
connector