Filter
Top Products
8-8 Dell Precision 210 Desktop Systems User’s Guide
Follow this procedure to perform a memory upgrade:
1. Remove the computer cover according to the instructions in “Removing the
Computer Cover” in Chapter 7.
2. To access the DIMM sockets on the system board, rotate the power supply as
described in “Rotating the Power Supply Away From the System Board” in
Chapter 7.
3. Determine the DIMM sockets in which you will install DIMMs or replace existing
DIMMs.
4. Install or replace DIMMs as necessary to reach the desired memory total.
Follow the instructions in “Installing a DIMM” or “Removing a DIMM,” as appro-
priate, found later in this section.
5. Rotate the power supply back into position, making sure the securing tab snaps
into place.
6. Replace the computer cover, and reconnect your computer and peripherals to
their power sources and turn them on.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
The system detects that the new memory does not match the existing system
configuration information and generates the following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
256 MB 128 MB 128 MB
384 MB 64 MB 64 MB 128 MB 128 MB
512 MB 128 MB 128 MB 128 MB 128 MB