Filter
Top Products
C-10 Dell Precision 210 Desktop Systems User’s Guide
WARNING: Could not
configure Plug and
Play Card Name.
WARNING: Could not
configure PCI device,
ID=DeviceID.
Failed to configure
Number of Total Count
Plug and Play ISA
devices. Use your
system’s configura-
tion utility to
resolve conflicts.
Press any key to
continue.
The card(s) mentioned are
not fully configured due
to resource conflicts.
If you do not know the allowable resource
values for your Plug and Play or PCI expansion
card, use the following procedure to locate
and resolve the resource conflict:
1. Remove all card configurations from the
ICU.
See “Removing a Card” in Chapter 4 for
instructions.
2. Reboot your system.
The ICU should automatically configure
your Plug and Play or PCI expansion card.
3. Add the ISA expansion cards back into
the ICU, resolving any resource conflicts
as they arise.
See “Adding a Listed Card” in Chapter 4
for instructions.
If your Plug and Play or PCI expansion card is
not automatically configured when you reboot
the system with all other cards removed, you
should contact the manufacturer of the card
or see the chapter titled “Getting Help” in
your
Diagnostics and Troubleshooting Guide
.
WARNING: Boot Device
conflict detected!
CSN=Card Select Num-
ber Error=Error.
One of the devices is
attempting to use one or
more resources assigned
to the system’s boot
device.
Perform the following procedure:
1. Start the ICU.
2. Identify the card marked config
err.
This card is attempting to use one or
more resources required by the system’s
boot device.
3. Follow the procedure for the preceding
error message in this table.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.