Filter
Top Products
ISA Configuration Utility Messages C-7
&RQILJXUDWLRQ0DQDJHU0HVVDJHV
The Configuration Manager for the ICU identifies problems following the system boot
routine and generates messages if necessary. These messages alert you to any
unsuccessful attempts to configure Plug and Play or Peripheral Component Inter-
connect (PCI) expansion cards, as well as any problems that interfere with the
operation of the Configuration Manager. If you receive a message from the Configura-
tion Manager, see Table C-2 for suggestions on resolving any problems indicated by
the message.
Found Plug and Play
ISA card:
Plug and Play
ISA Card Name
.
This message appears at
system start-up for each
Plug and Play ISA expan-
sion card recognized by
the Configuration
Manager.
Status message; no action is required.
NOTICE: Boot Device
Not Active! CSN=
Card
Select Number
.
A boot device was found
to be inactive.
Status message; no action is required. The
Configuration Manager automatically config-
ures and activates the device.
One or more active
devices have been
reconfigured -- sys-
tem requires reboot.
Press any key to
reboot system.
You modified the
resource values of one or
more PCI or Plug and Play
ISA expansion cards.
Reboot the system to reconfigure the card(s).
The Plug and Play ISA
card has been success-
fully configured.
Card Count Plug and
Play ISA cards have
been successfully
configured.
The Configuration Man-
ager has successfully
configured the given
number of cards.
If this message does not match the number
of Plug and Play ISA expansion cards installed
in your computer, reinstall any Plug and Play
expansion cards not listed and reboot the
system.
ERROR: Insufficient CM
Memory
There is not enough
memory available to the
Configuration Manager
for it to run.
Disable any TSR programs or any unneeded
device drivers.
ERROR: Fatal BIOS
error Internal Error
Code.
A BIOS call failed with an
internal error. The most
likely cause is an incom-
patibility between the
BIOS and the Configura-
tion Manager.
See the chapter titled “Getting Help” in your
Diagnostics and Troubleshooting Guide
for
instructions on obtaining technical assistance.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.