Filter
Top Products
Installing Drives 9-3
To replace a front-panel insert for a 5.25-inch bay,
work from inside the cover. Insert
the two ring-tabs (one on each end of the insert) over the posts on the inside of the
bay opening, and firmly press both ends of the insert into place (see Figure 9-2).
&RQQHFWLQJ'ULYHV
When installing a drive, you connect two cables—a DC power cable and an interface
cable—to the back of the drive. Your drive’s power input connector (to which you con-
nect the DC power cable) resembles the connector shown in Figure 9-3.
.
The drive’s interface connector is a card-edge connector or a header connector, as
shown in Figure 9-4.
posts (2)
ring-tabs (2)
power input
connector
DC power cable