Filter
Top Products
Setup: PmT1 and PmE1 Setup
10002367-02 PmT1 and PmE1 User’s Manual
2-5
Figure 2-4: PmT1 and PmE1 Installation
4 Insert and tighten the two remaining screws.
PMT1 AND PME1 SETUP
You need the following items to set up and check the operation of the Emerson PmT1 and
PmE1:
❐ Five-volt compatible PMC baseboard
❐ Chassis and power supply
❐ Serial interface cable for EIA-232 port, Emerson part #C0006322-xx0
❐ Two Compu-shield to RJ45 cable assemblies (Emerson part number C308A009-xx) for
front panel I/O configurations
❐ Computer terminal
Save the antistatic bag and box for future shipping or storage.
Caution: Do not install the board in a rack or remove the board from a rack while power is applied, at
risk of damage to the board.
Power Requirements
The Emerson PmT1 and PmE1 circuit board typically requires 6.7 watts maximum.
Tighten these two screws first.
Voltage key
!