Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
4-6
Reviewing LCD Messages (continued)
Message Cause Solution
Film Sensors are not
calibrated.
Your film Sensors must be
calibrated before the film will align
properly.
Press CALIBRATE to set
them at this time. See
Resolving a Transfer Film
Sensor Not Calibrated
Error .
Film is out! The transfer film has run out. Install a new roll of film
and press RESUME to
continue or CANCEL to
reset. See Resolving a
Transfer Film Out Error .
Transfer film not
installed.
The transfer film is not installed or
it is broken.
Install the film and press
RETRY or press IGNORE
to continue with no film
installed. See Resolving a
Transfer Film Not Installed
Error .
Flip Command Error A flip command was sent to a
Printer with no Flipper installed.
Cancel the print job and
send a single-sided print.
FPGA Load Fail! The FPGA is not responding. Verify that the Lamination
Module cable is seated
properly.
Head Temperature
Error
The Printhead is too hot. Allow the Printhead to cool
and press RESUME to
continue.
If the problem persists,
there may be a problem
with the temperature
Sensor or the Printhead
fan.
Call for technical
assistance.
Continued on the next page