Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
viii
Cleaning outside the Printer _________________________________________________________ 8-3
Cleaning the Printhead _____________________________________________________________ 8-4
Replacing the Card Cleaning Tape____________________________________________________ 8-5
Cleaning the Magnetic Encoder ______________________________________________________ 8-7
Cleaning the Platen and Transfer Rollers _______________________________________________ 8-9
Cleaning the Transfer Rollers using the Cleaning Card ___________________________________ 8-10
Section 9: Packing the Card Printer _________________________________________9-11
Section 10: Board Level Diagnostics _________________________________________10-1
Board Errors ______________________________________________________________________ 10-1
Resolving the EE Memory Error ____________________________________________________ 10-1
Resolving the EE Checksum Error___________________________________________________ 10-1
Resolving the DRAM Memory Error_________________________________________________ 10-2
Resolving the RAM Memory Error __________________________________________________ 10-2
Resolving the FPGA Error _________________________________________________________ 10-3
Sensor Testing_____________________________________________________________________ 10-3
Reviewing the Sensor Locations and Voltages__________________________________________ 10-4
Reviewing the Motor Locations and Cables____________________________________________10-6
Section 11: LCD On-Line Menu Navigation ___________________________________11-1
Entering the LCD Menu and selecting an Option __________________________________________ 11-1
Selecting from the HDP600 Menu Option Structure Tree _________________________________ 11-1
Reviewing the Printer Setup __________________________________________________________ 11-6
Preparing to Adjust the Print Offset, Transfer TOF and Transfer EOF _______________________ 11-8
Aligning the Print Offset __________________________________________________________ 11-9
Setting the Transfer TOF _________________________________________________________ 11-11
Setting the Transfer EOF _________________________________________________________ 11-13
Using the Gap Distance Table _____________________________________________________ 11-15
Adjusting the Transfer Tension ____________________________________________________ 11-18
Adjusting the Film Drive _________________________________________________________ 11-19
Adjusting the Ribbon Tension _____________________________________________________ 11-19
Adjusting the Ribbon Drive _______________________________________________________ 11-20
Adjusting the Transfer Temperature_________________________________________________ 11-20
Adjusting the Transfer Speed ______________________________________________________ 11-21
Setting the Printhead Resistance____________________________________________________ 11-21
Adjusting the Image Darkness _____________________________________________________ 11-22
Changing the Encoder Settings_____________________________________________________ 11-23
Setting the Magnetic TOF ________________________________________________________ 11-24
Setting the Magnetic TOF ________________________________________________________ 11-26
Adjusting the Flipper Offset_______________________________________________________ 11-27
Adjusting the Lamination Flipper Offset _____________________________________________ 11-28
Adjusting the LAM TOF and EOF__________________________________________________ 11-29
Adjusting the Lamination Sensor Calibration__________________________________________ 11-30
Adjusting the Lamination Temperature Setting ________________________________________ 11-30
Using the Show Card Count option _________________________________________________ 11-31
System Upgrade (Firmware Upgrade) _______________________________________________ 11-32
Section 12: Firmware Updates ______________________________________________12-1
Firmware Updater Application Program_________________________________________________ 12-1
Downloading Firmware Updates_______________________________________________________ 12-3
Updating the Printer's Firmware _______________________________________________________ 12-4
Updating the Main Firmware _______________________________________________________ 12-4
Updating the LCD Firmware _______________________________________________________ 12-7
Section 13: Fargo Technical Support ________________________________________13-1
Contacting Fargo Technical Support____________________________________________________ 13-1