Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
11-30
Adjusting the Lamination Sensor Calibration
Step Procedure
1 Applies only if the Printer is equipped with the Card Lamination Module. (Note:
This setting reports the current Lamination Sensor calibration setting as dictated
by the Printer Driver's Sensor calibration procedure. In most cases, this will not
need to be changed.)
Adjusting the Lamination Temperature Setting
Step Procedure
1 Applies only if the Printer is equipped with the Card Lamination Module.
Use this setting to change the nominal setting of the Lamination Roller. (Note:
In most cases, this will not need to be changed, as more direct control of the
Lamination Roller can be achieved through the Printer Driver.)