Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
3-8
Loading clear HDP Film into the Transfer Station
Step Procedure
1
Caution: Ensure that the Printer is turned off and the power cord is
unplugged from the Printer.
2 Load the HDP Film into the Transfer Station, as shown in three (3) photos
(Displays A to C) in this section. (Note: Be sure the film is fed from underneath
both rolls.)
See the next page.
Display A – Loading the HDP Film (supply spool)
(Note No. 1: HDP Film comes wound on a green spool with a yellow ring around one side.
Match the yellow ring on the Ribbon Spool to the yellow Hub inside the Printer. When
properly installed, the yellow ring will be in the upper-left-front position.)
(Note No. 2: Yellow colors still need to match. The Drive Hub is yellow on the HDP600
CR100 and HDP600-LC CR100 and the Hub needs to line up with the yellow Film Ring.)