Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
4-46
Resolving a No Magnetic Encoder Installed Error
Step Procedure
2 Press the Cancel Print button on the Driver Monitor Error Display
Message.
3 Reboot the Printer by cycling the power.
4 Verify that the Printer has a Magnetic Encoder installed.
a. Open the front cover.
b. Remove the Magnetic Module cover screw.
c. Remove the Magnetic Module cover.
d. Verify that the Printer has a Magnetic Module installed. (Note: If the
Printer is equipped with a Magnetic Encoder Module, ensure that it is
seated securely into the Magnetic Module docking station. If the issue
persists, replace the Magnetic Module. See the HDP600 service
manual for replacement procedures.)
5 If the Printer has no Magnetic Encoder Module, verify that the encoding
data was sent in error, check the appropriate software user’s manual for
encoding instructions.