FARGO electronic HDP600-LC CR100 Printer User Manual


 
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
4-55
Resolving a Ribbon Sensor Error (Ribbon Miscue)
Step Procedure
2 Open the front cover and remove the Ribbon.
a. Check that the Ribbon is in good condition and not wrinkled or broken.
b. If Ribbon is broke or wrinkled, repair the Ribbon and wind up the take-
up roll 4-color panels past the damaged area.
3 Press on the Resume button.
If the issue persists, continue to Step 4.
4 Replace the Ribbon.
a. Press on the Resume button.
b. If the issue persists, continue to Step 5.
5 Press the Cancel Print button on the Driver Monitor Error Display
Message.
6 Reboot the Printer by cycling the power.
7 Using the driver calibration tab calibrate the Ribbon Sensor.
If the issue persists, continue to Step 8.
8 Replace the Ribbon Sensor.