Filter
Top Products
175
PRIMERGY TX200 S2 User’s Guide
Installing hardware options
7
• When installing/removing hardware options to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Also unplug
all power cables from the outlet. Failure to do so can cause electric shock
("1.4.4 Turning Off the Server" (pg.36)).
• Do not disassemble the PSU. Failure to do so can cause electric shock.
• Do not install unauthorized third party hardware options. Doing so may cause
a device failure, fire, or electric shock.
• Do not damage or modify internal cables or devices. Doing so may cause a
device failure, fire, or electric shock.
• Devices inside the server remain hot after shutdown. Wait for approximately
10 minutes after shutdown before installing or removing hardware options.
• The circuit boards and soldered parts of hardware options are exposed. They
can be damaged by static electricity.
Before handling them, first touch a metal part of the server to discharge static
electricity.
• Do not touch the circuitry on boards and soldered parts. Hold the metallic
areas or the edge of the circuit boards.
• When installing a 5-inch internal device, make sure to avoid pinching cables.
• If devices are installed other than by the methods outlined in this chapter or
disassembled, the warranty will be invalidated.