Filter
Top Products
23
PRIMERGY TX200 S2 User’s Guide
1
Overview
e Maintenance switch
This switch is used only by maintenance personnel. Do not touch this.
f System status LED ( )
This LED lights or blinks in amber when an error is detected in the server components. If this
LED lights or blinks, contact your maintenance engineer or device administrator.
g Hard disk access LED ( )
This LED blinks when data is being written to or read from the hard disk.
However, this LED does not light when an array system is configured using a RAID Ctrl 2-
Channel 128MB w/ BBU (PG-142E3). Check the hard disk access display LED of each internal
hard disk for the access status.
h Power LED ( )
This LED is lit green when the server is turned on.
This is lit amber when the server is not turned on (standby mode).
This does not light when the power cable is unplugged from the outlet.
i Power switch
Press this switch to turn the server on.
Do not turn the server off when the hard disk access LED is blinking.
Data in the hard disk may be damaged.
j 5-inch storage bay
Contains a 5-inch internal device.
k CD-ROM drive
Reads data or programs from a CD-ROM.
l CD-ROM eject button
Press this button to eject a CD-ROM.
Do not press this when the CD-ROM access LED is on.
m CD-ROM access LED
This LED blinks when data is being read from a CD-ROM.
n Floppy disk drive
Writes/reads data to/from a floppy disk.
o Floppy disk eject button
Press this button to eject a floppy disk.
Do not press this when the floppy disk access LED is on.
p Floppy disk access LED
This LED blinks when data is being written to or read from a floppy disk.
q Drive cover
This slides up and down.
r USB port ( )
Connects peripheral equipment conforming to the USB standard (2.0 or 1.1).