Filter
Top Products
200
Chapter 7 Installing Hardware Options
● When the Eth. Ctrl 1000-BASE-T Cu (PG-1852) is Installed in Slot 5
Before installing the Eth. Ctrl 1000-BASE-T Cu (PG-1852) in Slot 5, remove the cover from the Eth.
Ctrl 1000-BASE-T Cu (PG-1852).
When installing the card to the PCI board, use the four stoppers to fasten the card.
For the driver installation procedure, refer to README.txt supplied with the driver.
■ Installing the Remote Service Board
●
Notes Before Installing
When installing the remote service board, note the following points:
• Do not connect the remote service board AC adapter until you finish installing
the remote service board and attaching all the server covers. Failure to do so
may cause a device failure, fire, or electric shock.
• When replacing remote service boards or adding other optional devices,
unplug the power cable of the remote service board AC adapter from the outlet
before operation. Failure to do so may cause a device failure, fire, or electric
shock.
Cover
Screws