Filter
Top Products
List of Figures
FIGURE 1 - HyperTerminal screen showing the serial settings ................................................................. 25
FIGURE 2 - Prompt indicating the switch model number as well as mode of operation – note the
commands to switch between the levels is not shown here. ............................................................. 26
F
IGURE 3 – As the switch tries to determine its mode of operation and its IP address, it may
assign and release the IP address a number of times. A continuous ping to the switch will
show an intermittent response ..................................................................................................... 27
F
IGURE 4 - Setting IP address on the switch ......................................................................................... 28
FIGURE 5 - Rebooting the switch ........................................................................................................... 28
FIGURE 6 - Viewing the basic setup parameters. You can use ‘show setup’ or ‘show sysconfig’ to
view setup parameters ................................................................................................................ 29
FIGURE 7 - Switching users and privilege levels. Note the prompt changes with the new privilege
level. ......................................................................................................................................... 30
FIGURE 8 - Adding a user with Manager level privilege ........................................................................ 31
FIGURE 9 - Deleting a user .................................................................................................................. 31
FIGURE 10 - Changing the password for a specific user ......................................................................... 31
FIGURE 11 - Changing the privilege levels for a user .............................................................................. 32
FIGURE 12 – Creating user access privileges .......................................................................................... 33
F
IGURE 13 – Creating user access privileges .......................................................................................... 33
FIGURE 14 - Help command .............................................................................................................. 34
FIGURE 15 - Help for a specific command ........................................................................................... 34
F
IGURE 16 - Options for the ‘show’ command ...................................................................................... 35
FIGURE 17 - Listing commands available (at the operator level) ............................................................ 35
FIGURE 18 - Listing commands starting with a specific character .......................................................... 35
FIGURE 19 - Listing commands options – note the command was not completed and the TAB
key completed the command. ...................................................................................................... 36
FIGURE 20 – logout command .............................................................................................................. 36
FIGURE 21 – Upgrading to MNS-6K-SECURE ............................................................................... 37
FIGURE 22 - Checking the IP settings .................................................................................................. 40
FIGURE 23 - Changing the boot mode of the switch ............................................................................... 42
xi