MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Command Description
clear <history|log [1..5 |informational
|activity |critical |fatal |debug]
|terminal |arp|portstats|addr]
clear command to clear various aspects of the
MNS-6K information – most notably “clear
addr” – clears the addresses learnt or “clear log”
to clear the logs (and the type of logs)
clear log [fatal |alert| crit|error| warn|
note|info|debug]
clear logs or specific type of logs
clear-reserveip ip=<ip> clear the reverse IP assigned
climode <script|console|show>
set the interactive CLI mode on (console) or off
(script). To see the mode – use the show option
com2sec <add|delete> id=<id>
[secname=<name>] [source=<source>]
[community=<community>]
a part of the View based Access control model
(VACM) as defined in RFC 2275. This
specifies the mapping from a source/community
pair to a security name. On MNS-6K, up to 10
entries can be specified
command
<Enter>
options for a command
community [write=<write community>]
[read=<read community>] [trap=<trap
community>]
set the necessary community strings
config startip=<start ip>
endip=<endip> mask=<mask> [dns=<
dns1, dns2,..dns10>]
[gateway=<gateway>]
[leasetime=<lease time(1..10 hours)>]
configure the DHCP lease request parameters
such as starting IP address, ending IP address,
DNS server parameters, default gateway IP
address and lease time
configure access sets the access parameters e.g. disable telnet
session
cost port=<number|list|range>
value=<0-65535>
cost is specific to a port and the port(s) have to
be specified
configure port-security sets the port authorization based on MAC
addresses
configure vlan type=port enter the VLAN configuration commands
cost port=<number|list|range>
value=<0-65535>
cost is specific to a port and the port(s) have to
be specified
deftrap community=<string> defines the default community string to be used
when sending traps. When user does not specify
the trap community name when setting a trap
station using the “trap” command, the default
trap community name is used
305