Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
228
Magnum6K25(igmp)## mode normal
IGMP set to Normal Mode.
Magnum6K25(igmp)## exit
Magnum6K25#
FIGURE 126 - Setting IGMP-L2
List of commands in this chapter
Syntax igmp – IGMP configuration mode
Syntax igmp <enable|disable> - enable or disable IGMP on the switch
yntax show igmp – IGMP operation status
yntax mcast <enable | disable> - enable or disable unknown multicast streams. The default is enabled
yntax set igmp mode=<normal|l2> - set the IGMP mode. Normal is when a L3 device is in the
yntax group add ip=<group ip> port=<number|list|range> vlan=<vlanid> - add ports to a
g ip> - delete ports from a specific IGMP broadcast group
yntax show-group – shows the multicast groups
yntax set-port port=< port|list|range> mode=<auto|forward|block> - set the port
yntax show-port – display the port characteristics for IGMP
P-enabled router ports
ables or disables the switch to immediately process a host sending a
yntax set-querier <enable|disable> - enables or disables a switch as IGMP querier
yntax set-qi interval=<value> - The IGMP querier router periodically sends general host-query messages.
These messages are sent to ask for group membership information. This is sent to the all-system multicast
S
S
S
network and is the IGMP root. The IGMP-L2 is used when there is no L3 device in the network
S
specific IGMP broadcast
roup del ip=<group
S
S
characteristics. Block drops the unregistered multicasts. Forward forwards unregistered multicasts
S
Syntax show-router – displays detected IGM
Syntax set-leave <enable|disable> - en
leave message rather that wait for the timer to expire
S
S