Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Magnum6K25# set secrets hide
Secrets will be hidden.
Magnum6K25# set secrets show
Secrets will be visible.
Magnum6K25#
FIGURE 47 – Hide or display system passwords
Erasing configuration
To erase the configuration and reset the configurations to factory default, you can use the
command ‘kill config’. This command is a “hidden command” i.e. the on-line help and other help
functions normally do not display this command. The ‘kill config’ command resets everything to
the factory default. The reset does not take place till the switch reboots.
It is recommended to save the configuration (using ‘saveconf’ command
discussed above) before using the ‘kill config’ command. The ‘kill config’ will
also reset the IP address and all other parameters as well unless the save option
described below is used.
Syntax kill config [save=module-name] – resets the system configuration. The module-name
option does not reset the specific module parameters. The modules are listed below
The module-names are
Name Areas affected
system IP Configuration, Boot mode, Users settings (e.g.
login names, passwords)
event Event Log and Alarm settings
port Port settings, Broadcast Protection and QoS
settings
bridge Age time setting
stp STP, RSTP, S- Ring and LLL settings
ps Port Security settings
mirror Port Mirror settings
sntp SNTP settings
vlan VLAN settings
gvrp GVRP settings
snmp SNMP settings
web Web and SSL/TLS settings
tacacs TACACS+ settings
auth 802.1x Settings
igmp IGMP Settings
65