Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
• Auto – lets IGMP control whether the port should or should not participate sending
multicast traffic
• Block – manually configures the port to always block multicast traffic
• Forward – manually configures the port to always forward multicast traffic
To set the port characteristics, use the set-port in the IGMP configuration command mode
Syntax set-port port=< port|list|range> mode=<auto|forward|block> - set the port
characteristics. Block drops the unregistered multicasts. Forward forwards unregistered multicasts
Syntax show-port – display the port characteristics for IGMP
Syntax show-router – displays detected IGMP-enabled router ports
Syntax set-leave <enable|disable> - enables or disables the switch to immediately process a host
sending a leave message rather that wait for the timer to expire
Syntax set-querier <enable|disable> - enables or disables a switch as IGMP querier
Syntax set-qi interval=<value> - The IGMP querier router periodically sends general host-query
messages. These messages are sent to ask for group membership information. This is sent to the all-
system multicast group address, 224.0.0.1. The default value is 125 seconds. The valid range can be
from 60 to 127 seconds.
Syntax set-qri interval=<value> - The query response interval is the maximum amount of time that
can elapse between when the querier router sends a host-query message and when it receives a response
from a host. The Default value is 10 seconds. The Range can be from 2 to 270 seconds. Restrictions
apply to the maximum value because of an internal calculation that is dependent on the value of the
Query Interval.
Magnum6K25# igmp
Magnum6K25(igmp)## set-port port=10-12 mode=forward
Port mode is set.
Magnum6K25(igmp)## set-port port=14-16 mode=block
Port mode is set.
Magnum6K25(igmp)## show-port
-----------------------------------
Port | Mode
-----------------------------------
09 Auto
224