Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
158
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
Magnum6K25(stp)##
FIGURE 86 – Configuring STP parameters
List of commands in this chapter
his
command lists the switch’s full STP configuration, including ge
s
rt (Enable) or stop (Disable) STP
-65535> - specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports a -
Syntax c rt(s)
have to be specified
Syntax p ber|list|range> status=<enable|disable> - specific ports may not need to
participate in STP process. These ports typically would be end-stations. If you
Syntax timers forward-delay=<4-30> hello=<1-10> age=<6-160> - change the STP Forward
Delay, Hello timer and Aging timer values
Syntax
show stp <config|ports > - regardless of whether STP is enabled or disabled (default) t
neral settings and port settings
tp – STP Configuration mode Syntax
Syntax stp <enable|disable> - Sta
Syntax priority [port=<number|list|range>] value=<0-255 | 0
nd their value is 0
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
ost port=<number|list|range> value=<0-65535> - cost is specific to a port and the po
ort port=<num
are not sure – let MNS-6K
software make the decisions