Filter
Top Products
MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Link-Loss-Learn Enabled.
Magnum6K25(stp)## lll add port=1,2,3
Added Ports: 1,2,3
Magnum6K25(stp)##show lll
Link-Loss-Learn Status:
LLL Status: ENABLED
LLL Enabled on Ports: 1,2,3
Magnum6K25(stp)## lll del port=2,3
Deleted Ports: 2,3
Magnum6K25(stp)## lll disable
Link-Loss-Learn Disabled.
FIGURE 97 – Link Loss Learn (LLL) setup. Setup LLL on ports connected to other switches
participating in S-Ring
List of commands in this chapter
Syntax authorize <module> key=<security key> - activate the S-Ring capabilities. Don’t forget
to use the “save” command to save the key
Syntax stp – STP Configuration mode
Syntax stp <enable|disable> - Start (Enable) or stop (Disable) STP
Syntax set stp type=<stp|rstp> - set the spanning tree protocol to be IEEE 802.1d or 802.1w
(Spanning Tree Protocol or Rapid Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show s-ring – show the status of S-Ring status and configuration
Syntax s-ring <enable|disable> - enable or disable S-Ring capabilities
Syntax s-ring learn – start the learning process to discover the ring and the ports which make up the S-
Ring
Syntax s-ring add port=<port1,port2> - define ports which make up the S-ring ports. Note as
discussed earlier, you can create multiple S-Rings on a switch
Syntax s-ring del port=<port1,port2> - remove the switch from S-Ring topology by eliminating the
end ports on the switch
Syntax lll <enable|disable> - enable or disable LLL on the switch
185