Filter
Top Products
EN
Understanding the print server configuration page
181
0D LAN ERROR –
TRANSMITTER OFF
There might be a problem with your network cabling or the
print server. Check the cabling and connectors on your
Ethernet network. If you cannot find a problem with your
network cabling, run the power-on self-test: remove and
re-attach the power module connector on the print server. If
the error persists, there is a problem with the print server.
0E LAN ERROR – LOSS OF
CARRIER
Check the network connections. If the connections are intact,
run the power-on self-test: remove and re-attach the power
module connector on the print server. If the error persists,
replace the print server.
10 LAN ERROR –
UNDERFLOW
There might be a problem with your network cabling or the
print server. Check the cabling and connectors on your
network. If you cannot find a problem with your network
cabling, run the power-on self-test: remove and re-attach the
power module connector on the print server. If the error
persists, there is a problem with the print server.
11 LAN ERROR – RETRY
FAULTS
There is a problem with your network cabling or external
network configuration. Make sure that the hub or switch port is
operating.
12 LAN ERROR –
NO LINKBEAT
With a 10Base-T or 100Base-TX port connected, Link Beat is
not sensed. Check the network cable, and make sure that the
concentrator or hub is providing Link Beat.
13 NETWORK RECONFIG –
MUST REBOOT
To enable the new configuration values, reset the print server
or turn the print server off and back on.
28 OUT OF BUFFERS The print server could not allocate a buffer from its internal
memory. This means that all of the buffers are busy, which
might be a result of heavy broadcast traffic or large amounts
of network traffic directed to the print server.
40 ARP DUPLICATE IP
ADDRESS
The ARP layer detected another node on the network using
the same IP address as the print server. Extended error
information below this message shows the hardware address
of the other node.
41 NOVRAM ERROR The print server cannot read the contents of its NOVRAM.
Error Code and Message Description