Filter
Top Products
EN
Understanding the print server configuration page
183
4D CF ERR – ACCESS LIST
EXCEEDED
The TFTP configuration file specified too many access list
entries using the “allow:” keyword.
4E CF ERR – TRAP LIST
EXCEEDED
The TFTP configuration file specified too many trap
destination list entries using the “trap-destination:” keyword.
4F TFTP REMOTE ERROR The TFTP transfer of the configuration file from the host to the
print server failed with the remote host sending a TFTP
ERROR packet to the print server.
50 TFTP LOCAL ERROR The TFTP transfer of the configuration file from the host to the
print server failed with the local print server encountering
some form of inactivity timeout or excessive retransmissions
situation.
51 TFTP RETRIES
EXCEEDED
The overall retrying of the TFTP transfer of the configuration
file from the host to the print server has exceeded a retry limit.
52 BAD BOOTP/DHCP
REPLY
An error was detected in the BOOTP or DHCP reply that the
print server received. The reply either had insufficient data in
the UDP datagram to contain the minimum BOOTP/DHCP
header of 236 bytes, an operation field that was not
BOOTPREPLY(0X02), a header field that did not match the
print servers hardware address, or a UDP source port that
was not the BOOTP/DHCP server port (67/udp).
53 BAD BOOTP TAG SIZE The tag size in a vendor-specific field in the BOOTP reply is
either 0 or greater than the remaining number of unprocessed
bytes in the vendor-specified area.
54 BOOTP/RARP IN
PROGRESS
The print server is currently in the process of obtaining its
basic IP configuration information through BOOTP/RARP.
55 BOOTP/DHCP IN
PROGRESS
The print server is currently in the process of obtaining its
basic IP configuration information through BOOTP/DHCP and
has not detected any errors.
56 DHCP NAK The print server received a negative acknowledgement
message from the DHCP server in response to a configuration
request.
Error Code and Message Description