Filter
Top Products
EN
UNIX systems
57
d
To provide the WINS server’s IP address, perform the
following steps:
e
Select
Value
, and
Edit Array
.
f
From the
IP Address Array Editor
, select
Remove
to
delete any undesired addresses previously set. Type the
WINS server’s IP address, and select
Add
.
g
Once the address appears in the list of IP addresses,
select
OK
. This returns you to the
DHCP Options
window. If the address that you just added appears in the
list of IP addresses (near the bottom of the window)
return to step 10d. Otherwise, repeat step 10c.
h
In the
DHCP Options
window, select
WINS/NBT Node
Type (046)
from the
Unused Options
list. Select
Add
to
add the node type to the
Active Options
list. In the
Byte
box, type 0x4 to indicate a mixed node, and select
OK
.
11
To return to
Program Manager
, click
Close
.
Windows 2000 server
To set up a DHCP scope on a Windows 2000 server, perform the
following steps:
1
To run the Windows 2000 DHCP manager utility, click
Start
,
Settings
, and
Control Panel
. Open the
Administrative
Tools
folder, and run the
DHCP
utility.
2
In the DHCP window, find and select your Windows 2000
server in the DHCP tree. If your server is not listed in the
tree, select
DHCP
, and click the
Action
menu to add the
server.
3
After selecting your server in the DHCP tree, click the
Action
menu, and select
New Scope
. This runs the
Add New
Scope
Wizard.
4
In the
Add New Scope
Wizard, click
Next
.
5
Enter a name and description for this scope, and click
Next
.
6
Type the range of IP addresses for this scope (beginning IP
address and ending IP address). Also, type the subnet mask,
and click
Next
.
Note
If you are using subnetting, the subnet mask defines which portion of
an IP address specifies the subnet and which portion specifies the
client device.