Filter
Top Products
FCC Statement (Class B)
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•• Reorient or relocate the receiving antenna.
•• Increase the separation between the equipment and the receiver.
•• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•• Consult the dealer or an experienced radio/TV technician for help. Any changes or
modifications not expressly approved by Hewlett-Packard could void the user’s
authority to operate this equipment.
Note
Use of a shielded interface cable is required to comply within the Class B limits in
Part 15 of FCC rules.
VCCI Statement (Japan)
The VCCI statement below is required in Japan. It is similar to the FCC regulatory
statement.
VCCI Statement (Japan)
Figure B-1
B-4 Regulatory Information