Filter
Top Products
Face-Up/Face-Down Lever
1 Remove Printer Covers, Delivery Assembly (Figures 6-9 and 6-10), Fuser Pressure
Plate (Figure 6-11), and Heating Element (Figures 6-13 through 6-15), and Pressure
Roller (Figure 6-16).
2 Rotate the lever forward 90 degrees (past the spring) and pull it straight out the front
of the printer.
To reinstall
1 Make sure the lever arm is on the left and is initially pointing downward.
2 Pull the spring forward using needlenose pliers.
3 Slide the short, round tabs into the grooves on the Separation Guide Assembly. The
machined ridges on the lever will face you.
4 Release the spring so it falls in place in front of the square tab (Figure 6-17).
Face-Up/Face-Down Lever Replacement
Note
You can tell when the lever is in place because there are two plastic grooves that fit
precisely in front of the Exit Rollers, and you should be able to feel the spring’s
release mechanism.
Figure 6-17
Removal and Replacement 6 - 21