Filter
Top Products
Paper Exit Sensor Flag
1 Remove the Printer Covers, Delivery Assembly (Figures 6-9 and 6-10), and Fuser
Pressure Plate (Figure 6-11).
2 Remove the Paper Exit Sensor flag by pressing down on the left side and pulling up
on the right side.
To reinstall
Note
It is important that you reinstall the flag correctly, since installing it incorrectly will
cause the Control Panel to display an error with the Paper Exit Sensor (PS201).
Place the left side of the flag in the correct position first, then slide the right side
into place, making certain the spring is on top of the flag (Figure 6-19). The flag
should fit snugly in place.
Paper Exit Sensor Flag Replacement
Figure 6-19
Removal and Replacement 6 - 23