Filter
Top Products
● Fax over Internet Protocol (FoIP)
● An integrated services digital network (ISDN) service
If you experience problems sending and receiving faxes, you might want to try setting
the Fax Speed setting to Medium or Slow. The following table provides the available
fax speed settings.
Fax speed setting
Fax speed
Fast v.34 (33600 baud)
Medium v.17 (14400 baud)
Slow v.29 (9600 baud)
To set the fax speed from the control panel
1 Press Setup.
2 Press 5, and then press 7.
This selects Advanced Fax Setup and then selects Fax Speed.
3
Press
to select an option, and then press OK.
Reprint or delete the faxes in memory
You can reprint or delete the faxes stored in memory. You might need to reprint a fax
in memory if your HP all-in-one runs out of paper while receiving a fax. Or, if the
memory of the HP all-in-one becomes full, you might need to clear it in order to
continue receiving faxes.
Note The HP all-in-one stores all faxes it receives in memory, even when the faxes
are printed. This allows you to reprint the faxes later, if needed. After the memory
becomes full, the HP all-in-one overwrites the oldest, printed faxes as it receives new
faxes.
To reprint faxes in memory from the control panel
1 Make sure you have paper loaded in the input tray.
2 Press Setup.
3 Press 6, and then press 4.
This selects Tools and then selects Reprint Faxes in Memory.
The faxes are printed in the reverse order they were received with the most
recently received fax printed first, and so on.
4 If you do not need a fax that is printing, press Cancel.
The HP all-in-one begins printing the next fax in memory.
Note You will need to press Cancel for each stored fax in order to stop it from
printing.
To delete all the faxes in memory from the control panel
➔
To delete all the faxes from memory, turn off the HP all-in-one by pressing the On
button.
All faxes stored in memory will be deleted from memory after you turn off the power to
your HP all-in-one.
User Guide 95